Description
Staroxy EISL electric insulation coating designed to impart high dielectric strength for various electrical applications. When properly applied and dried, a tough film is formed over the surface. It offers excellent U.V radiation resistance coupled with tracking resistance which makes its use beneficial for outdoor exposure and in extreme weather conditions.
Advantages
-
High electric & insulation resistance.
-
Breakdown Voltage – (Tested at CPRI Bangalore) 13.95kV per mm
-
Durable and Abrasion Resistant
-
Seamless
-
Easy to apply
-
High Build High Adhesion
Intended Use
-
Di-electric flooring - control panel rooms
-
HT bus bar coating
-
Power transmission tower bases
Surface Preparation
-
Suitable methods are sanding or grinding. Any surfaces that have been contaminated with oils may also require chemical cleaning.
-
Use an industrial vacuum that picks up even small dust particles. The floor must be cleaned of all dusts and residues before starting to prime. Otherwise you will have various particles trapped within the coat and adhesion will be significantly weakened. The less micro-dust on the surface the less primer you will need.
-
For thin cracks it may be necessary to slice them with a cutter before filling in order to improve the anchoring of the grout.
Insulation Epoxy Primer -
Staroxy 111 MOT
-
Mix Part A and Part B of Staroxy 103 MOT with Electric Stirrer. Once parts A & B have been thoroughly mixed, the product may be thinned to aid application.
-
Apply the primer coat by brush and then roll the centre with a short nap roller.
-
Allow a drying time of at least 4 hours before applying basecoat. If you intend to install epoxy corner coving, this should be done before commencing the next step.
Insulation Epoxy Basecoat -
Staroxy EISL UL
-
The base coat used is usually Staroxy EISL UL. Mix Part A and Part B of the Staroxy EISL UL in a clean bucket with Electric Stirrer according to the instructions on the technical data sheet.
-
Starting at the far corner, apply the basecoat by trowel and roller and evenly broadcast the Sand if necessary, into the wet product until all the basecoat is covered, except at the leading edge.
Insulation Epoxy Topcoat -
​
Staroxy EISL 1000
-
It is a four-pack easy to apply, solvent free resin-based floor topping laid at 1mm with coverage of 10 Sq. Mtr. Per pack. It is specially formulated as part of a dielectric / insulative system. To provide a hard wearing, seamless, insulative floor with breakdown voltage in the range 13.95kV per mm which is certified by CPRI.
Insulation Epoxy Topcoat -
​
Staroxy EISL 2000
-
It is a four-pack easy to apply, solvent free resin-based floor topping laid at 2mm with coverage of 5 Sq. Mtr. Per pack. It is specially formulated as part of a dielectric / insulative system. To provide a hard wearing, seamless, insulative floor with breakdown voltage in the range 13.95kV per mm which is certified by CPRI.
Other Useful Products
-
Staroxy 20 SF – Sand Coving
-
Aggregates – Sand, Silica Powder, Talc Powder
-
Staroxy 21 WB – Water base Coving
-
Stancrete 33 PU – PU base Coving
-
Stanrocove 25 – Covefinish
-
Staroxy 22 – Epoxy Coving Paint
-
Starothane 23 – PU Coving Paint
-
Starothane Yellow/White – PU Yellow Lining Paint
-
Staroxy Yellow/White – Epoxy Yellow Lining Paint