Liberally apply Stanrose® Anti Moist Electrosolv on all surfaces and equipment to be cleaned and protected. This can be done by aerosol spray, brush, swab of immersion methods. For scaled/ solid surfaces apply Anti-Moist thoroughly to form protective film over descaled areas. Immersion of wet parts will cause water to fall off and sink to bottom of container. There is no need to remove Anti-Moist before using equipment. However, prior to painting of parts treated with Anti- Moist rising with Stanrose® Electrical Cleaning Solvent may be desirable. For restoration of electrical equipment and metal parts after flooding, firstly, remove salt water deposits and dirt with fresh water. Then saturate all parts of the equipment with Anti-Moist preferably by immersion. Periodic measurement of the insulation resistance will indicate return of equipment to operating conditions.